Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Compression release

Compression release 2 years 1 month ago #1526

I have a 69/70 B44 vs (pc79638) that's been rebuilt (not by me), the Compression release linkage appears to be hooked up properly, however when operated there no engagement with the valve, I played with the adjustment to no avail, I also disconnected the cable and took off the inspection plate and the lifter lever just flips back and forth loosely.

what would the fix be ?

Thanks so much
The administrator has disabled public write access.

Compression release 2 years 1 month ago #1530

  • Rich B
  • Rich B's Avatar
  • OFFLINE
  • Junior Boarder
  • Posts: 26
  • Thank you received: 5
  • Karma: 2
The lever is likely not on the operating shaft correctly. The arm will need to come off and repositioned to allow the lever to engage the rocker arm.

It is a fiddly job.......
Last Edit: 2 years 1 month ago by Rich B.
The administrator has disabled public write access.

Compression release 2 years 1 month ago #1531

Thanks, Guess that means getting into the rocker box and going from there ? I'll check workshop manual
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 0.202 seconds
Powered by Kunena Forum